1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
|
/*
* stm-fmc.c
* ---------
* Functions to set up and use the FMC bus.
*
* Copyright (c) 2015, NORDUnet A/S All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are
* met:
* - Redistributions of source code must retain the above copyright notice,
* this list of conditions and the following disclaimer.
*
* - Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* - Neither the name of the NORDUnet nor the names of its contributors may
* be used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS
* IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
* PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
* HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
* TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
* PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
* LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
* NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
* SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
#include "stm-init.h"
#include "stm-fmc.h"
static SRAM_HandleTypeDef _fmc_fpga_inst;
void fmc_init(void)
{
static int initialized = 0;
if (initialized) return;
initialized = 1;
// configure fmc pins
GPIO_InitTypeDef GPIO_InitStruct;
// enable fmc clock
__HAL_RCC_FMC_CLK_ENABLE();
fmc_af_gpio(GPIOB, GPIO_PIN_7);
fmc_af_gpio(GPIOD, GPIO_PIN_0 | GPIO_PIN_1 | GPIO_PIN_3 | GPIO_PIN_4
| GPIO_PIN_5 | GPIO_PIN_7 | GPIO_PIN_8 | GPIO_PIN_9
| GPIO_PIN_10 | GPIO_PIN_11 | GPIO_PIN_12 | GPIO_PIN_13
| GPIO_PIN_14 | GPIO_PIN_15);
/*
* When FMC is working with fixed latency, NWAIT pin (PD6) must not be
* configured in AF mode, according to STM32F429 errata.
*/
GPIO_InitStruct.Pin = GPIO_PIN_6;
GPIO_InitStruct.Mode = GPIO_MODE_INPUT;
GPIO_InitStruct.Pull = GPIO_PULLDOWN;
HAL_GPIO_Init(GPIOD, &GPIO_InitStruct);
fmc_af_gpio(GPIOE, GPIO_PIN_2
| GPIO_PIN_3 | GPIO_PIN_4 | GPIO_PIN_5 | GPIO_PIN_6 | GPIO_PIN_7
| GPIO_PIN_8 | GPIO_PIN_9 | GPIO_PIN_10 | GPIO_PIN_11
| GPIO_PIN_12 | GPIO_PIN_13 |GPIO_PIN_14 | GPIO_PIN_15);
fmc_af_gpio(GPIOF, GPIO_PIN_0 | GPIO_PIN_1 | GPIO_PIN_2 | GPIO_PIN_3
| GPIO_PIN_4 | GPIO_PIN_5 | GPIO_PIN_12 | GPIO_PIN_13
| GPIO_PIN_14 | GPIO_PIN_15);
fmc_af_gpio(GPIOG, GPIO_PIN_0 | GPIO_PIN_1 | GPIO_PIN_2 | GPIO_PIN_3
| GPIO_PIN_4 | GPIO_PIN_5);
fmc_af_gpio(GPIOH, GPIO_PIN_8 | GPIO_PIN_9 | GPIO_PIN_10 | GPIO_PIN_11
| GPIO_PIN_12 | GPIO_PIN_13 | GPIO_PIN_14 | GPIO_PIN_15);
fmc_af_gpio(GPIOI, GPIO_PIN_0 | GPIO_PIN_1 | GPIO_PIN_2 | GPIO_PIN_3
| GPIO_PIN_6 | GPIO_PIN_7 | GPIO_PIN_9 | GPIO_PIN_10);
// configure fmc registers
/*
* fill internal fields
*/
_fmc_fpga_inst.Instance = FMC_NORSRAM_DEVICE;
_fmc_fpga_inst.Extended = FMC_NORSRAM_EXTENDED_DEVICE;
/*
* configure fmc interface settings
*/
// use the first bank and corresponding chip select
_fmc_fpga_inst.Init.NSBank = FMC_NORSRAM_BANK1;
// data and address buses are separate
_fmc_fpga_inst.Init.DataAddressMux = FMC_DATA_ADDRESS_MUX_DISABLE;
// fpga mimics psram-type memory
_fmc_fpga_inst.Init.MemoryType = FMC_MEMORY_TYPE_PSRAM;
// data bus is 32-bit
_fmc_fpga_inst.Init.MemoryDataWidth = FMC_NORSRAM_MEM_BUS_WIDTH_32;
// read transaction is sync
_fmc_fpga_inst.Init.BurstAccessMode = FMC_BURST_ACCESS_MODE_ENABLE;
// this _must_ be configured to high, according to errata, otherwise
// the processor may hang after trying to access fpga via fmc
_fmc_fpga_inst.Init.WaitSignalPolarity = FMC_WAIT_SIGNAL_POLARITY_HIGH;
// wrap mode is not supported
_fmc_fpga_inst.Init.WrapMode = FMC_WRAP_MODE_DISABLE;
// don't care in fixed latency mode
_fmc_fpga_inst.Init.WaitSignalActive = FMC_WAIT_TIMING_BEFORE_WS;
// allow write access to fpga
_fmc_fpga_inst.Init.WriteOperation = FMC_WRITE_OPERATION_ENABLE;
// use fixed latency mode (ignore wait signal)
_fmc_fpga_inst.Init.WaitSignal = FMC_WAIT_SIGNAL_DISABLE;
// write and read have same timing
_fmc_fpga_inst.Init.ExtendedMode = FMC_EXTENDED_MODE_DISABLE;
// don't care in sync mode
_fmc_fpga_inst.Init.AsynchronousWait = FMC_ASYNCHRONOUS_WAIT_DISABLE;
// write transaction is sync
_fmc_fpga_inst.Init.WriteBurst = FMC_WRITE_BURST_ENABLE;
// keep clock always active
_fmc_fpga_inst.Init.ContinuousClock = FMC_CONTINUOUS_CLOCK_SYNC_ASYNC;
/*
* configure fmc timing parameters
*/
FMC_NORSRAM_TimingTypeDef fmc_timing;
// don't care in sync mode
fmc_timing.AddressSetupTime = 15;
// don't care in sync mode
fmc_timing.AddressHoldTime = 15;
// don't care in sync mode
fmc_timing.DataSetupTime = 255;
// not needed
fmc_timing.BusTurnAroundDuration = 0;
// use 45 MHz to match what FMC arbiter in the FPGA expects
fmc_timing.CLKDivision = 4; // 180/4
// use 6 to match what FMC arbiter in the FPGA expects
fmc_timing.DataLatency = 6;
// don't care in sync mode
fmc_timing.AccessMode = FMC_ACCESS_MODE_A;
// initialize fmc
HAL_SRAM_Init(&_fmc_fpga_inst, &fmc_timing, NULL);
// STM32 only enables FMC clock right before the very first read/write
// access. FPGA takes certain time (<= 100 us) to lock its PLL to this frequency,
// so a certain number of initial FMC transactions may be missed. One read transaction
// takes ~0.22 us (10 ticks @ 45 MHz), so doing ~500 dummy reads will make sure, that FPGA
// has already locked its PLL and is ready. Another way around is to repeatedly read
// some register that is guaranteed to have known value until reading starts returning
// correct data.
// to prevent compiler from optimizing this away, we pretent we're calculating sum
int cyc;
uint32_t sum = 0;
volatile uint32_t part;
for (cyc=0; cyc<500; cyc++)
{
part = *(__IO uint32_t *)FMC_FPGA_BASE_ADDR;
sum += part;
}
// dummy write to read-only address to not let the compiler remove the above loop
*(__IO uint32_t *)FMC_FPGA_BASE_ADDR = sum;
}
|
