diff options
Diffstat (limited to 'content/DevBridgeBoard.md')
| -rw-r--r-- | content/DevBridgeBoard.md | 45 |
1 files changed, 45 insertions, 0 deletions
diff --git a/content/DevBridgeBoard.md b/content/DevBridgeBoard.md new file mode 100644 index 0000000..a9310c9 --- /dev/null +++ b/content/DevBridgeBoard.md @@ -0,0 +1,45 @@ +Title: DevBridgeBoard +Author: sra +Date: 2016-12-15 22:43 +Modified: 2021-02-14 17:30 + + + +# dev-bridge board +In the process of developing the [AlphaBoardComponents]({filename}AlphaBoardComponents.md) design, the project has made what is known as the "dev-bridge board". + +This is a board, 100x70 mm, with about 2/3 of the components intended to be on the Alpha design. What is missing is basically the FPGA and it's supporting circuits. + +To date, the dev-bridge board has been used to implement and validate the FMC based interface that will be used to connect the ARM and the FPGA on the Alpha. + +Schematics and layouts are at [user/ft/stm32-dev-bridge/hardware/rev01](https://wiki.cryptech.is/browser/user/ft/stm32-dev-bridge/hardware/rev01). + +High resolution pictures of rev01 of the dev-bridge board are attached at the bottom of this page, but the following should be more than sufficient to read the silkscreens. + + + + + +Here is the board mounted on the Novena, attached to the programmer: + + + +Note that it's rather bigger than the Netgear enclosure I use to transport the Novena. (Not only does it protect the board, but I have this superstition that TSA is more comfortable with a home gateway than a bare motherboard.) + +Also note that the dev-bridge board is connected to the Novena by the +high-speed expansion connector, which forms a bit of a pivot point. +As Pavel says, "High speed and mechanical reliability are not very good +friends usually." + +For that reason, I highly recommend stabilizing the board by bolting it to +the Novena with a 5mm spacer. There are two through-holes that line up +with mounting holes on the Novena, one at the corner and one next to the +wifi connector. I've found that even one bolt is enough to stabilize the +board. + +Finally note that the board traces come rather close to the through-holes, so +you want to avoid scraping them with the bolt head or the nut. I happen to +be using a countersink-head bolt, which is beveled toward the shaft, but +it's probably even better to use a nylon washer. + +All the software, as well as flashing instructions, are at [sw/stm32](https://git.cryptech.is/sw/stm32.md). |