diff options
Diffstat (limited to 'src')
| -rw-r--r-- | src/rtl/README.md | 38 | ||||
| -rw-r--r-- | src/rtl/rosc_entropy.v | 2 | ||||
| -rw-r--r-- | src/rtl/rosc_entropy_core.v | 16 |
3 files changed, 9 insertions, 47 deletions
diff --git a/src/rtl/README.md b/src/rtl/README.md deleted file mode 100644 index 4986410..0000000 --- a/src/rtl/README.md +++ /dev/null @@ -1,38 +0,0 @@ -rosc_entropy -============ - -Digital entropy source based on on jitter between multiple, digital ring -oscillators. The entropy source is used in the TRNG as one of several -entropy sources feeding the mixer. - - -## Functionality ## - -The digital oscillators are created using adders. The carry out from the -adder are inverted and fed back into the adder as carry in. In -combination with operand values we basically get an inverted signal (the -carry out) that toggles reapeatedly. By having the operands externally -defined, synthesis tools in general will not optimize them away. - -The carry out signal is sampled with a clock that toggles at a much -slower rate than the intrinsic toggle rate of the carry out signal. In a -modern FPGA, the toggle rate may be 400+ MHz while the sample rate might -be 10 kHz. This sample time allows the differences in intrinsic toggle -frequency between separate oscillators to drift apart after sampling. - -The entropy source contains 32 separate oscillators. The outputs from -the oscillators are XOR-combined to create a single entropy bit. Entropy -bits are collected into 32-bit words which are provided to entropy -consumers. - - -## Implementation Results ## - -The entropy source has been implemented, tested and shown to produce -good quality entropy (using the ent estimation tool etc) in Altera -Cyclone-IV and Cyclone-V devices as well as in Xilinx Spartan-6. - -The Xilinx synthesis tool will try to optimize the combinational loop -away. (More specifically, it claims that the oscillator sample registers -will have a fixed value.). There is therefore an attribute in the source -code to force the tool to preserve the register. diff --git a/src/rtl/rosc_entropy.v b/src/rtl/rosc_entropy.v index 485b516..179f41c 100644 --- a/src/rtl/rosc_entropy.v +++ b/src/rtl/rosc_entropy.v @@ -169,7 +169,7 @@ module rosc_entropy( begin if (!reset_n) begin - enable_reg <= 1; + enable_reg <= 1'h1; op_a_reg <= DEFAULT_OP_A; op_b_reg <= DEFAULT_OP_B; end diff --git a/src/rtl/rosc_entropy_core.v b/src/rtl/rosc_entropy_core.v index 51ded81..cb5ca4b 100644 --- a/src/rtl/rosc_entropy_core.v +++ b/src/rtl/rosc_entropy_core.v @@ -162,15 +162,15 @@ module rosc_entropy_core( begin if (!reset_n) begin - ent_shift_reg <= 32'h00000000; - entropy_reg <= 32'h00000000; - entropy_valid_reg <= 0; - bit_ctr_reg <= 8'h00; - sample_ctr_reg <= 8'h00; - debug_delay_ctr_reg <= 32'h00000000; + ent_shift_reg <= 32'h0; + entropy_reg <= 32'h0; + entropy_valid_reg <= 1'h0; + bit_ctr_reg <= 8'h0; + sample_ctr_reg <= 8'h0; + debug_delay_ctr_reg <= 32'h0; warmup_cycle_ctr_reg <= WARMUP_CYCLES; - debug_reg <= 8'h00; - debug_update_reg <= 0; + debug_reg <= 8'h0; + debug_update_reg <= 1'h0; end else begin |