//======================================================================
//
// alpha_top.v
// ------------
// Top module for the Cryptech Alpha FPGA framework. This design
// allow us to run the FMC interface at one clock and cores including
// core selector with the always present global clock.
//
//
// Author: Pavel Shatov
// Copyright (c) 2016, 2018 NORDUnet A/S All rights reserved.
//
// Redistribution and use in source and binary forms, with or without
// modification, are permitted provided that the following conditions
// are met:
// - Redistributions of source code must retain the above copyright
// notice, this list of conditions and the following disclaimer.
//
// - Redistributions in binary form must reproduce the above copyright
// notice, this list of conditions and the following disclaimer in the
// documentation and/or other materials provided with the distribution.
//
// - Neither the name of the NORDUnet nor the names of its contributors may
// be used to endorse or promote products derived from this software
// without specific prior written permission.
//
// THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS
// IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
// TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
// PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
// HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
// SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
// TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
// PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF
// LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
// NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
// SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
//
//======================================================================
`timescale 1ns / 1ps
module alpha_fmc_top
(
input wire gclk_pin, // 50 MHz
input wire ct_noise, // cryptech avalanche noise circuit
input wire fmc_clk, // clock
input wire [23: 0] fmc_a, // address
inout wire [31: 0] fmc_d, // data
input wire fmc_ne1, // chip select
input wire fmc_noe, // output enable
input wire fmc_nwe, // write enable
input wire fmc_nl, // latch enable
output wire fmc_nwait,// wait
output wire mkm_sclk,
output wire mkm_cs_n,
input wire mkm_do,
output wire mkm_di,
output wire [3: 0] led_pins // {red, yellow, green, blue}
);
//----------------------------------------------------------------
// Clock Manager
//
// Clock manager is used to buffer FMC_CLK and implement reset logic.
// ----------------------------------------------------------------
wire sys_clk; // system clock (90 MHz)
wire sys_rst_n; // active-low reset
alpha_clkmgr clkmgr
(
.fmc_clk (fmc_clk),
.sys_clk (sys_clk),
.sys_rst_n (sys_rst_n)
);
//----------------------------------------------------------------
// FMC Arbiter
//
// FMC arbiter handles FMC accesses.
//----------------------------------------------------------------
wire [23: 0] sys_fmc_addr; // address
wire sys_fmc_wren; // write enable
wire sys_fmc_rden; // read enable
wire [31: 0] sys_fmc_dout; // data output (from STM32 to FPGA)
wire [31: 0] sys_fmc_din; // data input (from FPGA to STM32)
fmc_arbiter #
(
.NUM_ADDR_BITS(24) // change to 26 when Alpha is alive!
)
fmc
(
.fmc_a(fmc_a),
.fmc_d(fmc_d),
.fmc_ne1(fmc_ne1),
.fmc_nl(fmc_nl),
.fmc_nwe(fmc_nwe),
.fmc_noe(fmc_noe),
.fmc_nwait(fmc_nwait),
.sys_clk(sys_clk),
.sys_addr(sys_fmc_addr),
.sys_wr_en(sys_fmc_wren),
.sys_rd_en(sys_fmc_rden),
.sys_data_out(sys_fmc_dout),
.sys_data_in(sys_fmc_din)
);
//----------------------------------------------------------------
// LED Driver
//
// A simple utility LED driver that turns on the Alpha
// board LED when the FMC interface is active.
//----------------------------------------------------------------
fmc_indicator led
(
.sys_clk(sys_clk),
.sys_rst_n(sys_rst_n),
.fmc_active(sys_fmc_wren | sys_fmc_rden),
.led_out(led_pins[0])
);
//----------------------------------------------------------------
// Core Selector
//
// This multiplexer is used to map different types of cores, such as
// hashes, RNGs and ciphers to different regions (segments) of memory.
//----------------------------------------------------------------
core_selector cores
(
.sys_clk(sys_clk),
.sys_rst_n(sys_rst_n),
.sys_fmc_addr(sys_fmc_addr),
.sys_fmc_wr(sys_fmc_wren),
.sys_fmc_rd(sys_fmc_rden),
.sys_write_data(sys_fmc_dout),
.sys_read_data(sys_fmc_din),
.noise(ct_noise),
.mkm_sclk(mkm_sclk),
.mkm_cs_n(mkm_cs_n),
.mkm_do(mkm_do),
.mkm_di(mkm_di)
);
//
// Dummy assignment to bypass unconnected outpins pins check in BitGen
//
assign led_pins[3:1] = 3'b000;
endmodule
