#!/bin/sh
PROJ="${1?'project'}"
OPENOCD=openocd
# location of OpenOCD Board .cfg files (only used with 'make flash-target')
#
# This path is from Ubuntu 14.04.
#
OPENOCD_BOARD_DIR=/usr/share/openocd/scripts/board
# Configuration (cfg) file containing programming directives for OpenOCD
#
# If you are using an STLINK v2.0 from an STM32 F4 DISCOVERY board,
# set this variable to "stm32f4discovery.cfg".
#
# If you are using an STLINK v2.1 from an STM32 F4 NUCLEO board,
# set this variable to "st_nucleo_f401re.cfg".
#
# If you are using something else, look for a matching configuration file in
# the OPENOCD_BOARD_DIR directory.
#
OPENOCD_PROC_FILE=stm32f4discovery.cfg
if [ "x`lsusb -d 0483:374b`" != "x" ]; then
for fn in st_nucleo_f4.cfg st_nucleo_f401re.cfg; do
if [ -f "$OPENOCD_BOARD_DIR/$fn" ]; then
OPENOCD_PROC_FILE="$fn"
fi
done
fi
# This used to be "... verify reset exit", but that fails on Debian Jessie.
# The Net of a Million Lies claims that the "exit" is unnecessary, so the
# simplest solution is just to omit it. Should this turn out to be a mistake,
# well, we'll have to do something more clever to deal with these silly version
# skew problems between the several versions of openocd in current use.
$OPENOCD -f $OPENOCD_BOARD_DIR/$OPENOCD_PROC_FILE -c "program $PROJ.elf verify reset" # exit
ype='submit' value='switch'/>
Cryptech libhal: crypto software, HSM management, RPC | git repositories |
blob: b257604b04e83cb9bbe5a58140d318111888f288 (
plain) (
tree)