From 47edd24044d58d5368f8e5a45c26c94d6f6e4b26 Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?Joachim=20Stro=CC=88mbergson?= Date: Tue, 16 Oct 2018 10:55:09 +0200 Subject: (1) Replaced the README.md with the better one that for some reason lived in the rtl directory. (2) Cleaned up reset statatements as part of effort to check that all registers are being properly reset. --- src/rtl/README.md | 38 -------------------------------------- src/rtl/rosc_entropy.v | 2 +- src/rtl/rosc_entropy_core.v | 16 ++++++++-------- 3 files changed, 9 insertions(+), 47 deletions(-) delete mode 100644 src/rtl/README.md (limited to 'src') diff --git a/src/rtl/README.md b/src/rtl/README.md deleted file mode 100644 index 4986410..0000000 --- a/src/rtl/README.md +++ /dev/null @@ -1,38 +0,0 @@ -rosc_entropy -============ - -Digital entropy source based on on jitter between multiple, digital ring -oscillators. The entropy source is used in the TRNG as one of several -entropy sources feeding the mixer. - - -## Functionality ## - -The digital oscillators are created using adders. The carry out from the -adder are inverted and fed back into the adder as carry in. In -combination with operand values we basically get an inverted signal (the -carry out) that toggles reapeatedly. By having the operands externally -defined, synthesis tools in general will not optimize them away. - -The carry out signal is sampled with a clock that toggles at a much -slower rate than the intrinsic toggle rate of the carry out signal. In a -modern FPGA, the toggle rate may be 400+ MHz while the sample rate might -be 10 kHz. This sample time allows the differences in intrinsic toggle -frequency between separate oscillators to drift apart after sampling. - -The entropy source contains 32 separate oscillators. The outputs from -the oscillators are XOR-combined to create a single entropy bit. Entropy -bits are collected into 32-bit words which are provided to entropy -consumers. - - -## Implementation Results ## - -The entropy source has been implemented, tested and shown to produce -good quality entropy (using the ent estimation tool etc) in Altera -Cyclone-IV and Cyclone-V devices as well as in Xilinx Spartan-6. - -The Xilinx synthesis tool will try to optimize the combinational loop -away. (More specifically, it claims that the oscillator sample registers -will have a fixed value.). There is therefore an attribute in the source -code to force the tool to preserve the register. diff --git a/src/rtl/rosc_entropy.v b/src/rtl/rosc_entropy.v index 485b516..179f41c 100644 --- a/src/rtl/rosc_entropy.v +++ b/src/rtl/rosc_entropy.v @@ -169,7 +169,7 @@ module rosc_entropy( begin if (!reset_n) begin - enable_reg <= 1; + enable_reg <= 1'h1; op_a_reg <= DEFAULT_OP_A; op_b_reg <= DEFAULT_OP_B; end diff --git a/src/rtl/rosc_entropy_core.v b/src/rtl/rosc_entropy_core.v index 51ded81..cb5ca4b 100644 --- a/src/rtl/rosc_entropy_core.v +++ b/src/rtl/rosc_entropy_core.v @@ -162,15 +162,15 @@ module rosc_entropy_core( begin if (!reset_n) begin - ent_shift_reg <= 32'h00000000; - entropy_reg <= 32'h00000000; - entropy_valid_reg <= 0; - bit_ctr_reg <= 8'h00; - sample_ctr_reg <= 8'h00; - debug_delay_ctr_reg <= 32'h00000000; + ent_shift_reg <= 32'h0; + entropy_reg <= 32'h0; + entropy_valid_reg <= 1'h0; + bit_ctr_reg <= 8'h0; + sample_ctr_reg <= 8'h0; + debug_delay_ctr_reg <= 32'h0; warmup_cycle_ctr_reg <= WARMUP_CYCLES; - debug_reg <= 8'h00; - debug_update_reg <= 0; + debug_reg <= 8'h0; + debug_update_reg <= 1'h0; end else begin -- cgit v1.2.3